Drip Filters Aquarium

Having true unions and flush type valves will allow you to take your pump and/or other gear out of line and inspect it, replace it w/o having to drain your tank, sumps... useful to you? Yes.

About Balancing Water Flows Twixt Uneven Containers:

"Oh, Ill have equal rated pumps just shoot the water from one tank to the other..." Have I heard about flow valves, shut-off switches, magical siphon loops? On yes I have... There are folks who try to "defy gravity" by seeking to pump "just enough" water twixt and tween parts of their system... Alas, these all ultimately fail. Dont rely on a "make-up" siphon to save you

But there have been numerous instances of system pHs falling down to and below 7.0 without loss of life.

I mention this to make three points: 1) Dont get lost by focusing on specifics. A drop in pH by itself, or a rise/drop in most factors, is not cause for knee-jerk reaction. You dont want/need to over-react because, 2)

The literal placement of such pumps is also somewhat to very inconvenient for servicing. It is for these last reasons that I personally prefer to run a manifold off a proper sump pump

With any external pump installation, please be absolutely sure to use flanking slip unions (quick disconnects) a

You will find, however, that many obligations to water quality are much more strict with a heavy bio-load. Testing for less common parameters like oxygen saturation and phosphate levels may be easily overlooked (and certainly more easily corrected) in a smaller system, but a large aquarium requires due diligence, patience and planning to control these and other parameters. They are subject to the virtues and limitations of their very size. Both good and bad things are likely to happen slower in a large volume of water. We gain greater stability with increasing tank size. Thus, climbing nitrate levels are easily observed in advanc

The latest and greatest models are quiet, energy efficient and easy to use. If youre unfamiliar with their operation, ask your dealer to take one of each out of their box, review their instructions and peruse their elements. Most all are magnetic-drive pump powered with few moving parts. The fluid-moving mechanisms and filter media replacement should be known to you in terms of cost of operation, repair and replacement. There is a huge difference in the same lines by different manufacturers between efficiencies for intended sizes and types of systems.

Reply to tips for aquarium shots?

funfishtank.com posted a reply:

Dark room. Lights on in tank.

Use a tripod if you got one.

Experiment!