Ripleys Aquarium Gatlinburg

Barring the species-centricity of humans and our related all-consuming sense of self-importance, this chunk of matter we reside on should be called "Aqua" rather than Earth.

And what a body of water most of Aqua/Earths surface is! Roaring waves, churning currents, abyssal depths, life/death struggle

As previously mentioned, however, they have two major drawbacks. They (and the ballasts that power them) produce a lot of heat and use a lot of electricity. They also distribute light over a relatively limited area, so that several bulbs may be required for longer tanks. Unless an aquarium equipped with metal halide lighting is kept in a cool room and adequate ventilation is used above the waters surface, an aquarium chiller will be required to maintain a safe temperature for live-reef

Reef, cold, temperate or tropical, etc.; and consideration of food use of the organisms (herbivorous, planktivorous, piscivorous) metabolisms (slow to fast), as well as density (light to too much). Tanks with half as much life in them are easily four times easier to take care of.

Contributing Factors:

Irregardless of the type of set-up, filtration, or livestock you have the following applies in terms of system shape, circulation and aeration.

System Shape:

Flatter, shallower, more square systems are easi

On the plus side they are small, powerful, and inexpensive. On the negative side, my experience has shown these pumps to be unreliable and potentially dangerous. I have had a number simply fail to operate after just a year or two of service. Worse yet, I have also received mild shocks from a couple of these pumps. The potential for electrocution was the final straw. I systemically went through my customers tanks and replaced all the Rio pumps with comparable ones from other manufacturers. This was both a liability and cost-effectiveness issue. I can easily replace and bill a customer

Heaters come in sealed submersible or not formats. Get and use the former only. If you need one of two-hundred or more watts, get two of two thirds or so of that wattage each and place them in separate ends of the system, not in a sump. Place the heaters low in the tank (but not undergravel) to facilitate heat diffusion, and prevent you from breaking them. Most heaters are accidentally broken by removing or replacing them when theyre too darn hot! The should be set in the tank water for fifteen minutes plus before plugging in, and unplu

Reply to hi from discus breader in Portugal

Photography is a still of life posted a reply:

Hey
They are very interesting pictures that you have there. I am big fan of discuss fish, unfortunately there are no dealers who live near me and ihave to travel many miles.

DIY Aquarium Cave
This tidbit I recieved in the mail today was too good not to share. Mark Shoemaker and Esther Baum wrote these great 10 step do it yourself instructions for creating an....