Aquarium Choosing Fish Freshwater

erhaps even an engineered or DIY tower of some sort? How big is your pump? Where should it be placed? What about sizing the tubing to/from it? Should you leave open/space for adding other discharges, returns for a sump/refugium later?

All these issues and more should be considered before even buying your tank... as both glass and acrylic models can be custom-ordered/made and the former are much easier to drill/fit for lines before assembly. Check with your dealer or fabricator r

aquarium choosing fish freshwater

Temperature Control:

Unless you live in a permanently cool setting, maybe a refrigerated cooler or Antarctica, you will absolutely need a chiller/cooling mechanism of some sort. Most cold water systems are intended to keep organisms between 50 and 65 degrees F.. If, you capitalize on using livestock collected inter-tidally (with more resistance to thermal et al. fluctuation

.. no detectable ammonia, nitrites; low nitrates (less than 10ppm), low phosphate (PO4, less than 0.05 mg/l), high redox (up to 425), elevated calcium (ideally 400-475 mg/l), pH 8.0-8.4, alkalinity 2.5-5 meq/l, near-saturation oxygen (generally about 7 mg/l)...

Here is a brief review of filtration types employed for reef use, with my comments on their suitability, and current

They can then be swiveled to finesse the dynamic of water flow in the aquarium as corals grow or wane, or when the seascape changes for any other reason. A slight restriction of water flow can be achieved by heating another short stem of pipe and crimping it to produce a restricted flare-tip that will increase the velocity of effluent water. This modified nipple is to be placed, of course, into an effluent tee. Some discretion is required here, however, as the resistance from a single crimped outlet will likely translate into water taking an easier path of resistance namely, another open outlet(s). To compens

Placement of the manifold at or slightly below the water surface (the nozzles at least) reduces or eliminates any issues with salt creep or salt spray.

Tapped into the manifold ring we need multiple tees, angled slightly downward as a good-sense precaution in case the nozzles leak or become "liberated". The placement of these tees is not of much critical concern as long as you have enough in total to work with; the ability to manipulate water flow through any of them is very flexible and efficient. Ill suggest 4 to 6 teed outlets per 100 gallons of tank volume, spac

Reply to tips for aquarium shots?

funfishtank.com posted a reply:

Dark room. Lights on in tank.

U.

Complimentary Goldfish
I've heard of people traveling with dogs, cats, and even an occasional fish. But this Chicago hotel takes vacationing with pets to a new level. They will provide a goldfish....

Breeding Clownfish

Breeding Clownfish
By William Berg

Thanks to Disney's Motion Picture 'Finding Nemo', almost everybody is famili.

Need help with DIY Moonlights
I'm looking for ideas to put moonlights in my 30 gallon Eclipse system hood. Where you guys get your Moonlights from, I check Canadian Tire & HD, they don't have it and BA and e-bay costing a lot. .